Aluminum foil oiling can be divided into sheet aluminum foil according to its shape. Most of the raw materials for the deep processing of aluminum foil are supplied in roll form. Only a few manual packaging occasions use aluminum foil. Aluminum foil coating oil can be divided into hard foil and soft foil according to its status. Aluminum foil oiled hard foil: Rolled aluminum foil without softening treatment (annealing) and degreasing treatment has a residual surface.
Aluminum foil coated with oil is a stamping material made of aluminum rolled directly onto a thin sheet. The stamping effect of aluminum foil coated with oil is similar to that of pure silver foil, so it is also called fake silver foil. Due to its softness and ductility, aluminum has a silvery-white luster. Aluminum foil can also be printed if the rolled sheet is mounted on offset paper with sodium silicate and other materials.
Knife beam type electrostatic oiling equipment is oil pump directly on the knife beam, through the tiny gap of the knife beam to spray oil. Because the gap of the knife beam is very small, so the oil purity requirements are very high. In actual production, it is impossible to completely clean the annealed strip or the cleaned strip surface with more or less residual iron powder and dust, which will inevitably cause the knife beam (especially the lower knife beam) to be blocked during the continuous production process, resulting in uneven oiling or leakage on the strip surface. Nozzle type electrostatic oiling equipment uses air pressure to pump oil to the nozzle and then sprays the oil out, so even if there are some tiny impurities in the oil under the pressure of the pump and air, the nozzle will not be clogged. Even if there is slight clogging, the impurities can be blown out of the nozzle by directly increasing the air flow, thus ensuring the quality of oiling.
WRITE A MESSAGE TO US